Skip to content
Publications

Article · Eastern-European Journal of Enterprise Technologies · August 28, 2026

Establishment of stress-strain state formation patterns during steel strip rolling in convex-concave rolls

Gulbarshyn Smailova, Assemgul Uderbayeva, K.K. Nurakhmetova, Шолпан Кошанова, K. Sansyzbayev, Zhamila Shakenova

Abstract

The object of study is the stress-strain state of the steel strip when rolling in special convex-concave rolls. The work solves the problem of the evolution of stresses and deformations during combined rolling-bending, limiting the prediction of limit states and the choice of rolling modes in rolls of unconventional geometry. It was found that with an increase in equivalent deformation from 0 to 0.358, tangential deformation increases from 0 to 0.875, and radial deformation changes from 0 to –0.803, with a decrease in thickness under the influence of compressive load. Axial deformation reaches a maximum (about 0.140) at the deformation stage and becomes negative at the final stage due to redistribution of deformations during combined rolling-bending. The tangential stress coefficient increases from 0.500 to 2.716, and the axial coefficient decreases from 0.500 to –1.955, showing a natural change in the stress state. Analysis of analytical calculations with experimental data shows discrepancies of results not exceeding 5–7%. Large degrees of deformation provide high prediction accuracy compared to the theory of small elastoplastic deformations. The obtained results justify the geometry of convex-concave rolls, in which tangential tension and radial compression is accompanied by redistribution of axial deformation and leads to the formation of a uniform stress-strain state in the deformation zone. This applies to low carbon steels, which mechanical properties are close to those of 08kp steel (DC01 according to EN 10130/AISI 1008), under isothermal rolling conditions with strip contact with rolls and deformation degrees not exceeding ε = 0.358. This approach allows to increase the stability of the technological process, predict the limit states of deformation and improve the quality of strips in industrial conditions

Metal Forming Simulation TechniquesMetallurgy and Material FormingMicrostructure and Mechanical Properties of Steelssteel strip rollingstress-strain statehoop stress

More by Gulbarshyn Smailova